Installing a replacement controller on Voltbike rear hub

Installing a replacement controller on Voltbike rear hub

This video will walk you through the steps of replacing a controller on VoltBike Yukon 2018/2019 and future models. Before you start, make sure that you remove the battery to make sure there is no accidental activation of the motor or any of the electrical components.


    • Related Articles

    • Replacing nylon gears on a Bafang hub motor

      If you experience consistent grinding noise coming from the rear hub then it's possible that the motor gears need to be replaced. This is a relatively rare issue and if it happens is usually after the first year of ownership. The video below shows ...

    • How to adjust rear derailleur on your VoltBike

      In this video, we are going to show you how to adjust the rear derailleur on your VoltBike. You will learn how to use limiting screws and how to fine-tune your gear shifting system. This technique should work for most Shimano rear derailleurs on the ...

    • LCD screen and keypad replacement

      LCD screen and keypad replacement Tools Required: • 3mm hex tool • 2.5mm hex tool Parts: The replacement LCD will include the following: • LCD with attached keypad • LCD mounting bracket • rubber shims (not needed for 31.8mm handlebars) • 4mm bolts ...

    • LCD screen and keypad replacement

      Tools Required: • 3mm hex tool • 2.5mm hex tool Parts: The replacement LCD will include the following: • LCD with attached keypad • LCD mounting bracket • rubber shims (not needed for 31.8mm handlebars) • 4mm bolts (x2) for mounting LCD to bracket • ...

    • VoltBike - Basic Bike Operation

      In this video, we will provide a basic overview of the operation of our rear-hub motor electric bikes, including the Yukon, Bravo, Elegant, Mariner, and Outback models