Known Issues
How to replace the inner tube on electric bike VoltBike Mariner
Inner tube replacement on VoltBike Yukon 750
Creaking sound from headset
This video will walk you through the steps of greasing your bicycle headset. This is required only if you experience an issue with creaking when turning. Before you start, make sure that you have generic grease, 4mm, 5mm and 6mm allen keys.
Installing a replacement controller on Voltbike rear hub
This video will walk you through the steps of replacing a controller on VoltBike Yukon 2018/2019 and future models. Before you start, make sure that you remove the battery to make sure there is no accidental activation of the motor or any of the ...
Freewheel removal - over sized motor plug
In the past, some models of the Yukon came with an oversized power chord plug for the hub motor which restricted the ability to use a standard freewheel removal tool. This article covers the process of removing the freewheel on such Yukons. Tools ...
How to replace brake pads on Yukon 750
This video will walk you through the steps of replacing disc brake pads on VoltBike Yukon or other VoltBike models using hydraulic disc brakes. Before you start, make sure that you have 5mm allen key, 2mm allen key, flat head screwdriver and ...
Can you overcharge the battery by leaving it charging too long?
All of our bike model chargers are smart chargers meaning they will auto-shut off once the charge cycle has completed.
Do you have spare keys? I lost mine.
All sets of keys delivered with every Voltbike are unique to each battery enclosure. This is why we provide our customers with a set of 2 keys in case one goes missing you still have a backup. Just like any car dealership, we would not hold on to ...
Hydraulic lever position - set screw adjustment
For Voltbike models: With Tektro hydraulic brakes Tools required: 2mm hex key Non-permanent thread locker (i.e. blue Loctite 242) If your Voltbike has hydraulic brakes/ levers there is the option to adjust the brake lever reach to fit various hand ...
Lock-Out Top Cap Fix for Suntour Suspension Forks
Tools required: Small flat screwdriver 5mm hex tool 4mm hex tool Needle nose pliers Your new Voltbike may have a Suntour front suspension fork that has a dual-position lock-out dial on the RH side that allows the rider to open and lock the suspension ...
Replacing nylon gears on a Bafang hub motor
If you experience consistent grinding noise coming from the rear hub then it's possible that the motor gears need to be replaced. This is a relatively rare issue and if it happens is usually after the first year of ownership. The video below shows ...
How to adjust rear derailleur on your VoltBike
In this video, we are going to show you how to adjust the rear derailleur on your VoltBike. You will learn how to use limiting screws and how to fine-tune your gear shifting system. This technique should work for most Shimano rear derailleurs on the ...
How to adjust mechanical disc brakes on your VoltBike
In this video, you going to learn how to adjust the mechanical disc brakes on our VoltBike. At this moment we use mechanical disc brakes Tektro on most of our models. If your VoltBike is using Tektro disc brakes then this video is for you.
Degreasing brake rotors on VoltBike to eliminate noise when stopping
This video will walk you through the steps of degreasing disc brake rotors on VoltBike Yukon or other VoltBike models using hydraulic disc brakes. This procedure is required only if you experience noise when stopping the bike.