How do I replace the button cover cap for my LCD screen?
Power Button Plastic Top Cap replacement
For all Voltbike models
Tools/ parts required:
Small Phillips screwdriver
2.5mm hex too
Power ‘off’ the bike and remove the battery. Use a 2.5mm hex tool to uninstall the
power button from the handlebar.
Use a small Phillips screwdriver to loosen and remove the plastic top cap mounting
screws on the bottom of the unit.
With all four screws removed, carefully replace the plastic top cap and rubber seal boot as
needed.
Ensure the new rubber seal boot and plastic cap are seated properly. Reinstall the four
screws. Check the screws are snug, but do not over-tighten or strip the threads. Remount the
power button on the handlebar. Install the battery and test ride.
Related Articles
How do I replace the button cover cap for my LCD screen?
ower Button Plastic Top Cap replacement For all Voltbike models Tools/ parts required: Small Phillips screwdriver 2.5mm hex too Power ‘off’ the bike and remove the battery. Use a 2.5mm hex tool to uninstall the power button from the handlebar. Use a ...LCD screen and keypad replacement
LCD screen and keypad replacement Tools Required: • 3mm hex tool • 2.5mm hex tool Parts: The replacement LCD will include the following: • LCD with attached keypad • LCD mounting bracket • rubber shims (not needed for 31.8mm handlebars) • 4mm bolts ...LCD screen and keypad replacement
Tools Required: • 3mm hex tool • 2.5mm hex tool Parts: The replacement LCD will include the following: • LCD with attached keypad • LCD mounting bracket • rubber shims (not needed for 31.8mm handlebars) • 4mm bolts (x2) for mounting LCD to bracket • ...How do I remove my LCD screen?
LCD replacement This article covers how to replace the LCD and control keypad, should either of them require replacement due to damage or malfunction. The LCD is permanently connected to the keypad. The LCD circuitry is potted to seal it from ...LCD Screen settings for VoltBike Urban
The settings below are for the latest VoltBike Urban 2018/2019 edition with S.Widom LCD screen panel. Please note that those settings are not compatible for the previous generations. P01：LCD backlight brightness. Default is 2. P02：Switch between KM ...